Toolbars
The NX user interface supports the use of toolbars to allow quick access to functionality via logical groupings of common functionality displayed as icons.
Each application has a set of toolbars which support functions within that application (e.g. Modeling, Drafting, Assemblies, etc.).
When you exit an NX session, the state of the toolbars can be saved so that they will displayed the same when you start a new session.
This is controlled by the Save layout at exit option under the General tab in the Preferences→User Interface dialog.
Toolbars may be in one of two states:
• Docked toolbars (1) are anchored to the main NX window, either horizontally or vertically. Docked toolbars are always within the NX
window.
• Undocked toolbars (2) are free floating on the screen. These toolbars are shown within the NX window, but may be located outside the window depending on screen setup.
Practical Applications of NX
Student Guide
©2006 UGS Corporation
All Rights Reserved.
Produced in the United States of America.
2 Practical Applications of NX mt10050_g NX 4
untuk lebih lengkap dan update tentang unigraphics simple tutorial silahkan kunjungi :
www.unigraphicsimpletutorial.blogspot.com
0 Response to "Toolbars"
Post a Comment